Hi....is there anyone that can tell me how to program a keyless remote for a 1999 Park AVE? Thanks for any info..

 

hello</span>



Most remotes
can be programmed manually at home without any tools or technical skills. </span>



If you need to
just order the instructions please check our website at </span>



http://www.carandtruckremotes.com/pr...instructions.h tml</span>



If you have any
more questions or have any specific inquiries about programming your vehicle
please contact us at customercare@carandtruckremotes.com
including year, make and model of your vehicle. </span>















You can also
view our FAQ page for answers to common questions. Link below
http://www.carandtruckremotes.com/faq.html

Best Regards
Customer Care </span>

http://www.carandtruckremotes.com</span>

http://www.newkeylessremotes.com</span>

http://www.keylessentrystore.com</span>

 

1. Insert keys in ignition and leave in the OFF position.

2. Locate the OBDII Port under drivers side dashboard.
(Note port is wider at top) Your OBDII Port will not have numbers, use this for reference.





3. Make sure there are metal contact pins in terminals 8 and 4. Connect 8 and 4 with a suitable jumper wire (leave the jumper wire connected throughout the programming procedure). Make sure you know which terminals are 8 and 4. The vehicle will respond by locking then unlocking the doors to signify entering of programming mode.

4. Close Doors

5. Turn ignition to the ON position (as far as you can go without cranking the engine). Doors will lock.

6. Press and hold both the LOCK and UNLOCK buttons together on the first transmitter to be programmed. Up to about 30 seconds, the vehicle will respond by locking then unlocking the doors. Release the buttons on the transmitter.


7. Within one minute, repeat the previous step on the remaining transmitter (if any – including any existing remotes).


8. Remove jumper wire applied to the OBDII Port.