service stabilitrack
#1
service stabilitrack
Not sure if I got the right forum. You guys can redirect me if it's not .Thanks but here goes. I replaced both rear air shocks with spring over strut design. I disconnected both air lines going to the air shocks and disconnected air compressor. When finished I got a service stabilitrack message streaming on my dash. The stabilitrack light is on indicating it is disengaged and I can't shut it off by selecting stabilitrack switch. All 4 wheel speed sensors read about 1K OHM which is correct,What I really need is a wiring diagram of the stabilitrack system so I can check other sensors and the wiring.
Last edited by Vincent Kieley; 09-07-2020 at 04:57 PM. Reason: incomplete
Thread
Thread Starter
Forum
Replies
Last Post